clean water drainge mixed flow pump

cast iron material farm irrigation mixed flow pump

Performance Range:

a)Capacities: (Q )up to 7000m3/h

b)Heads: (H )up to 25m

c)Operating pressure: (P) up to 0.6Mpa

d)Operating temperature: -20degrees to +120degrees.

Pump Overview

HW Series volute clean water irrigation pump is according to the national standard latest series

designed , with high efficiency energy saving features , its performance indicators are achieved

international advanced level, especially for material remarkable energy saving.

Driving mode: HW mixed flow pump can be used diesel engine, motor drive, its transmission

ways depending on the regions power up.

Pump features

1)HW pump combines the pump cover, impeller, shaft, bushings and bearings and other major

components.

2) Pump cover connects to pump and inlet respectively. There should be adequate clearance

between plane and the impeller pump cover. Actual appropriate clearance is 0.3 ~ 0.7mm (

the shaft into the pump inlet), the gap can be adjusted by changing the paper pad thickness.

3) Seal device consists of packing, packing gland, packing ring, and pump the fill ring. Its role is

to prevent air suction pump and prevent excessive water flow out from pump along the axial.

4)Axil sleeve is to protect the shaft. Timely replacement after worn.

5) Simple, reliable, easy fitting, and high efficiency, small size and light weight. Applies to trans-

port water or other liquids physical and chemical properties similar to water. Temperature

of transmission fluid is nothigher than 50 C.

HW Pump photos

We will reply you within 12 hours.